> >>3D6 HPA Grip for M4 Skeleton Stippling
3D6 HPA Grip for M4 Skeleton Stippling - View larger

3D6 HPA Grip for M4 Skeleton Stippling

3D6-HPAG-2TS

New product

In stock

Moyenne des votes pour ce produit
0 / 5
Moyenne : 0 / 5
Basée sur 0 avis clients.

16,58 € tax excl.

Si vous souhaitez enregistrer votre configuration, vous devez d'abord vous connecter.

Connexion

More info

This HPA M4 Grip is made by 3d printing technology, it is adding a nice touch on you replica with the openstyle / Skeleton design. Its architecture also allows to hide the 6mm hose of the HPA system directly in the profile of the grip and  become invisible. Compatible with all HPA systems with a 6mm macroline hose (or less outer diameter), be careful however only the hose can be slipped inside the grip, so it will be necessary to install US or EU connector after installation.

Instructions: start by inserting your hose at the entrance of the grip in the sheath, and once out use the four fixing screws provided to fix it on your replica. You can then finalize the installation by adding your HPA connector.

Data sheet

TypeM4
Weight70gr
MaterialPolymer - 3D print
Main colorBlack

3D6

3D6

See all products from 3D6

Questions  (2)

A partir de Janne | 2024-03-02 13:52:43

Hello. Is this Grip compatible with Maple Leaf MLC S2 Rifle Stock for VSR-10? Thank You.

Powair6

Hello , no it is not compatible .

Regards,

A partir de Maximilian | 2022-11-29 20:51:28

Is it possible to fit the Kythera leash through the grip too?

Powair6

Hello;
yes, all hoses less than 6 mm.
Best regards.

Page: 1
Seuls les utilisateurs enregistrés peuvent poser une question. Login

Avis

Seuls les clients enregistrés peuvent poster un avis. Connectez-vous ou créez un compte .
Tri:

Aucun avis pour le moment.