Shopping Cart
- Complete wiring is designed for airsoft replica AR15 with battery in the stock.
- Everything is ready, just solder the loose wires to the original trigger contacts in the gun.
- The Micro mosfet III is integrated into the DeanT connector so it takes up minimal space.
MOSFET BENEFITS:
- Increases gun rate of fire and battery holds longer, than with basic wiring.
- Designed for spring up to M170 (equivalent for current 90A single shot fire or 35A burst fire for max. 30s).
- Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- No current consumption in the idle mode
- No sparking on switch contacts
- Board covered by conformal coating, it protect it against water
SPECIFICATIONS:
- AR mosfet is suitable for installation with original V2 contacts in AR15, M4, SR25, MP5 or G3 airsoft gun
- The complete wiring allows quick and easy installation into the weapon, it is designed for all types of AR weapons with the battery located in the stock
- There are high quality powerwires 1,5 qmm (AWG16) with with thin and hard PTFE insulation and signal blue wire 0.34 qmm (AWG22) with PTFE insulation
- In auto fire mode piston stops in random position due the gearbox design
- For right function is necessary to have a functional gearbox cut off lever, selector plate, reverse latch, trigger and trigger block, as it has the standard gearbox
PACKING:
- Micro mosfet III soldered on T-Plug connector with complete wiring for battery in stock for AR15, M4, SR25, MP5 or G3 airsoft gun
- Installation manual in English
